スピーカーケーブルの位相補償回路2022年10月23日 20:20

プリアンプとパワーアンプ間に位相補償回路を追加する
スピーカーケーブルのインダクタンスによる位相遅れは線形ですので、単純な回路で補償できます。

プリアンプとパワーアンプ間を細工して、スピーカーケーブルへの入力を進み補償しました。

補償の精度が落ちますが、高周波でのゲインが高くなりすぎると危険ですので、コンデンサと直列に抵抗を接続しました。

パラメータを完全に詰めていませんが、約1/3の位相遅れになりました。

The phase delay due to speaker cable inductance is linear and can be compensated for with a simple circuit.

The input to the speaker cable was progressively compensated by modifying the connection between the preamplifier and the power amplifier.

Although the accuracy of the compensation is reduced, I connected a resistor in series with the capacitor because it is dangerous if the gain becomes too high at high frequencies.

Although the parameters were not fully worked out, the phase delay was reduced by about 1/3.

コメント

コメントをどうぞ

※メールアドレスとURLの入力は必須ではありません。 入力されたメールアドレスは記事に反映されず、ブログの管理者のみが参照できます。

※なお、送られたコメントはブログの管理者が確認するまで公開されません。

名前:
メールアドレス:
URL:
コメント:

トラックバック

このエントリのトラックバックURL: http://unique-cae.asablo.jp/blog/2022/10/23/9535451/tb

※なお、送られたトラックバックはブログの管理者が確認するまで公開されません。